DUROPOXY-15K Epoxy Grout

It is recommended to check the colour of the grout, if it is meeting the desired colour of the client It is recommended to do a small area with actual tile/stone at site and check for any colour ingress into the tile/stone. Many tiles / stones have high absorption which may lead to discoloration / colour marks. Plan to provide proper movement joints, peripheral joints as per EJ 171 to accommodate movements in tile/stone and use flexible grout / sealant to fill these movement joints. DUROPOXY-15K Epoxy grout and does not accommodate movements in tile/stone that can occur due to various reasons. Movements which occur in the tile/stone area due to non provision of movement joints will lead to cracks / breakage of grout joints / tile/ stone. Keep the working area covered and protected from Sun light while application of Duropoxy-15k epoxy grout, is applied in open areas like swimming pools etc. Keep the cover for 7 days and till the filling of pools with water after the completion of grouting with Duropoxy-15k, epoxy grout.

Before starting to grout, remove debris in grout joints and lightly sponge the tile surface to remove dust and dirt. Do not clean tiles with acid cleaners. In case acid cleaners were used to clean the tiles, ensure to wash the area with plenty of water before commencing grouting. Substrate temperature must between 16°C and 32°C.

Empty entire contents of Duropoxy-15k Epoxy Grout Part “A” and Part “B” container into a clean mixing pail. Mix with a margin trowel or a slow speed drill mixer until liquids are completely blended. Add at least ¾ of Duropoxy-15k Epoxy Grout Part “C” Filler Powder and mix to a uniform consistency. Add the remaining filler powder and mix to achieve a stiff mix to work into the joints. Immediately pour entire contents of bucket onto working area. Use a plastic sheet as a drop cloth. Use standard epoxy grouting techniques to work with Duropoxy-15k Epoxy Grout into tile joints. Duropoxy- 15k Epoxy Grout can also be applied with a caulking gun. Be sure all grout joints are packed full. Remove as much excess material as possible before initial cleaning with grout float. Do not leave excess grout on the face of tiles.

Remove excess grout from the face of the tiles with the edge of the grout float. Hold the float at a 90° angle and pull it diagonally across the joints and tile to avoid pulling out the material. Initial Cleaning: After 30-40 min of the application of the grout scrub the surface of the tile & joint with clean water and scrubber provided to remove any excess grout. Then take a clean thick white towel and drag across the tile to remove any residue. Final Cleaning: within 24 hours do a second cleaning with normal soap detergent to remove any haze from the tile

DUROPOXY-15K Epoxy grouts require routine cleaning with neutral pH soap and water. All other Duroxz materials require no maintenance but proper installation as per instruction. Performance and durability may depend on properly maintaining of Installed area.

DUROXZ ITAL CHEMTECH PRIVATE LIMITED warrants that DUROPOXY-15K Epoxy Grout is free from manufacturing defects and will not break down, deteriorate or disintegrate under normal usage for a period of two (2) years from manufacturing of the product subject to the terms and conditions stated in DUROXZ Product Warranty.

Factory sealed containers of this product are guaranteed to be of first quality for two (2) years if stored at temperatures 0°C and 38°C.

Light colors may darken slightly from direct UV exposure. Maximum stain resistance is achieved 10 days after installation. Protect from exposure to acids and strong cleaners during this period. Not recommended for soft, polished marble or delicate glazed tiles.